Mounting the ventilation unit on the wall

Heat recovery in ventilation units without enthalpy heat exchangers produces condensate, which must be properly drained off via the condensate drain. Provide sufficient space for the condensate drain under the unit. Ventilation units with ET enthalpy heat exchangers do not require a condensate drain.

Functional impairment due to condensate if the ventilation unit is not aligned. The ventilation unit must be installed horizontally so that the condensate can drain off unhindered.

1

Front panel

2

Magnet

3

Tab

4

Internal cover

  1. Tilt front panel forwards at the two top corners (detach from the magnets) and remove upwards.
  2. Loosen the 4 screws of the internal cover (bayonet lock) and remove it. Note information on sticker.

  3. S1

    Unit rail, preassembled

    S2

    Wall rail

  4. 1

    Rubber pads

  5. Mount the wall rail on the wall using suitable mounting material. Unit rail [S1] is pre-installed. Suitable mounting material is to be provided by the customer. Make sure it is horizontal.
  6. Stick the two rubber pads as spacers to the lower corners of the rear of the unit.
  7. Hang the ventilation unit in the wall rail. The unit rail and wall rail must cover one another completely, the unit must make contact with both rubber pads on the wall.