Electrical connection

DANGER: risk of electric shock, fire or short circuit

• Observe the safety rules of electrical engineering. Before taking off covers and before installing the electrics, shut down all supply circuits, switch off mains fuse, check that no voltage is present, secure against being accidentally switched back on and position a visible warning sign.

• Observe the applicable regulations for electrical installations, e.g. DIN EN 50110-1 and DIN EN 60204-1, in Germany in particular VDE 0100 with the corresponding parts.

• Only connect the ventilation unit to a permanently wired electrical installation in accordance with circuit diagram/wiring diagram.

• Note the voltage and frequency stated on the rating plate:
  230 V AC for RLS 45 O, RLS 45 K, PP 45 RC, PPB 30 RC
  12 V DC for PP 45 O, PPB 30 K, RV 2

• Use a mains isolation device with contact openings of at least 3 mm at each pole. Avoid contact with components (damage due to static charge).

• Use approved connection cables:
  Mains connection/230 V: Type NYM-J 5G 1.5 mm²
  Control cables: Type J-YSTY, 0.8 mm, 4-core, max. 25 m from star point, max. 4 m to star point.

• The ventilation units and control systems are not suitable for use in protection zones. PP 45and RV 2 ventilation units with IP rating IP 00, PPB 30 ventilation units with IP X4 → Risk of electric shock/short circuit due to ingress of moisture or condensation → Damage to the unit due to ingress of moisture. Protect the ventilation unit from humidity and moisture.

Permitted installation in protection zones

• When using the RLS 45 O/RLS 45 K control, ensure that it is correctly connected to the signal input. If the 230 V mains voltage is connected incorrectly in the connection area/at the signal input → Danger of electric shock, fire or short circuit if this is not observed. Ensure a phase balance between all components connected to the ventilation system.

• No or insufficient separation of the 12 V/24 V extra-low voltage with 230 V → If not observed, danger of electric shock, fire or short circuit. Ensure a safety distance between 230 V and SELV cables. Observe a minimum distance of 8 mm

DANGER of short circuit/fire with 230 V units (PP 45 RC, PPB 30 RC):
If moisture or condensation enters the terminal compartment, there is a risk of short circuit and fire, e.g. if the cable grommet is fitted incorrectly or if the wall sleeve is installed at an angle towards the interior wall. Ensure that the cable grommet is firmly and tightly seated in the housing. The inner front cover must engage correctly in the housing and be tight all round. The wall sleeve must not be inclined to the interior wall (permissible installation position 1° to 2° inclination to the exterior wall). Seal additionally, if necessary.

ATTENTION regarding 12 V DC units:
Damage to the unit if moisture or condensation enters the terminal compartment of the ventilation unit (in the event of incorrect installation). IP rating for PP 45 and RV 2 units = IP 00; for PPB 30 units = IP X4.
Cable grommet for the PPB 30 O/K units: The grommet must be firmly and tightly seated in the housing, the inner front cover must be correctly engaged in the housing and tight all round. Seal additionally if necessary.
Wall sleeve for PP 45 and PPB 30: The wall sleeve must not be angled towards the interior wall. Fit the wall sleeve with a 1 to 2° angle towards the exterior wall.
RV 2 terminal box devices: Fit the cover tightly all round. The mounting sleeve, external cover and internal cover must be fitted correctly and tightly.