Installation
Shutter does not close correctly if it is installed under tension.
- In order to guarantee the shutter function, only mount the shutter on a flat surface.
- Allow sufficient space to the wall or ceiling.
- Recommendation: Install a Ø 12 mm duct in the wall between the two deflection sleeves.
- Mounting material must be supplied on site.
- Observeminimum distance “X” (→ Unit overview) to a fan (EZQ/DZQ, EZF/DZF) installed in the wall.
Minimum distance “X” to EZQ/DZQ and EZF/DZF fans
| EZQ, DZQ | EZF, DZF |
|---|---|---|
RS 20 | 185 | 160 |
RS 25 | 215 | 190 |
RS 30 | 245 | 210 |
RS 35 | 275 | 245 |
RS 40 | 305 | 265 |
RS 45 | 330 | 320 |
RS 50 | 370 | 320 |
RS 60 | 430 | – |
- Open the lamellae of the shutter, align the shutter.
- Mark the 4 drilling positions of the fixing holes, drill and insert the dowels.
- Place the protective grille on the back of the shutter.
- Screw the shutter including the protective grille to the wall with 4 screws.
- Fit the two deflection sleeves.
- Guide the pull cord through the wall/deflection sleeves.
- Attach the cord clamp at the installation site.
- Cut the pull cord to length and attach the pulling knob.
- Run function test. The shutters must open and close completely.