Fitting the RV 2 AL external covers

RV 2 AL soffit variants = Accessories for RV 2 VLR (right) and RV 2 VLL (left) pre-installation kits

Figure RV 2 VLR. Not shown RV 2 VLL.

1

RV 2 pre-installation kit 90° (soffit)

2

External grille – soffit

3

Fixing screw (2 pcs.)

Observe safety instructions!

CAUTION Risk of injury when handling housing parts with sharp components, e.g. stainless steel external covers. Wear protective gloves.

  1. Once the external plastering is complete, remove the plaster protective cover. The 90° deflection unit of the RV 2 mounting sleeve must be plastered flush.
  2. Clean the condensate drain of the RV 2 mounting sleeve. The condensate must be able to drain freely.
  3. Insert the external grille into the 90° deflection unit and screw tight with the two fixing screws provided. ATTENTION: Ensure condensate drainage. Condensate must not penetrate between the mounting sleeve and the exterior wall.
  4. Check and ensure that the external grille is firmly seated.
  5. Recommendation: Additionally seal the external grille.