Installation instructions
ATTENTION: Damage to buildings and units if condensation or driving rain runs inwards into the mounting sleeve or into the masonry due to an incorrectly installed and aligned mounting sleeve.
The mounting sleeve may only be installed by qualified personnel in accordance with the applicable standards and building regulations. Observe the accident prevention regulations and occupational health and safety measures (intact protective clothing, secure footing etc.).
DANGER due to electric shock if the mounting sleeve is installed incorrectly. Water and moisture inside the mounting sleeve can cause a short circuit and damage the mounting sleeve when the slide-in module is used. Align and seal the mounting sleeve correctly during installation. Install the window sill plate with at least 40 mm of projecting length in accordance with the planning documents.
Layer height under the mounting sleeve depends on the planned parapet height.