Radio operation with EnOcean wireless components

The PP 45 EO EnOcean module (EnOcean extension module) can only be taught in with the commissioning software.

The teach-in mode is switched on with the software and a radio telegram is sent. All radio sensors/radio switches are taught-in directly on the PP 45 EO. Only the EnOcean module is taught-in on the master RLS 45 K.

The teach-in procedure is described in detail in chapter EnOcean wireless menu.

Teaching-in DS 45 RC radio switch

  1. Switch off the mains fuse and secure it against being switched on again.
  2. Glue the DS 45 RC to the wall at the installation location. Alternatively, the radio switch can also be screwed onto the wall (mounting material provided by customer).
  3. Connect the EnOcean extension module PP 45 EO to the RS 485 bus of the RLS 45 K control unit (RS 485 bus terminals), see connection and wiring diagrams in the appendix. If possible, wire in a separate junction box.
  4. Connect the RLS 45 K room air control to the PC/notebook (USB).
  5. Switch the mains fuse on.
  6. Using the commissioning software at specialist installer level, call up the EnOcean wireless menu, activate EnOcean wireless and teach in the radio switch as described.

Teaching-in radio sensor

  1. To install the radio sensor, see its installation instructions.
  2. Use the commissioning software to call up the EnOcean wireless menu chapter, activate EnOcean wireless and teach in the radio sensor as described.